Pommel bolster

Can affect the rider's pelvis tilt, refines the twist, and slightly deepens the seat. It goes under the front of the seat, with the wide side toward the pommel and the pointy side toward the rider. It can be moved forward/back for a greater effect.
Riders who have a low pelvic floor may not like the bolster. For those who are looking at the product to tilt the pelvis, one of the other rider balancing aids will have a great effect without discomfort.
To install, release the velcro under the front center of the seat, then tug the seat back over the front dees. Place the bolster and press the seat back into position, making sure all is still symmetrical. Replace the front velcro tab and push the seat back over the front dees. This last part can be difficult, especially when the saddle is new - to make it easier, pull some twine or a shoelace through the dee to give you more leverage.

Be the first to review this product

Size

$20.00

Qty:

Customers who bought this item also bought

Ghost seat reducer

Velcro wedge to reduce seat size about 2cm (1/2-3/4"). It has a bit of cushion as well. To install, carefully pull the seat forward over the cantle. Don't go too far because there are velcro tabs at the bottom of the seat. Position the seat reducer as desired and press the seat back into place. You may need to lean across the back of the seat to push it down far enough for the velcro logo on the cantle to grab.

$20.00

Stirrup straps & keepers

These stirrup straps are thin, yet very strong. Made from granite biothane, they'll hold up longer than leather but don't create a bump under your leg. Even better when you run the buckle at the bottom and use the handy keeper to put the excess strap neatly out of the way.
The standard configuration Ghost stirrup straps are 1" granite biothane and can work with any stirrup style. These are the only Ghost stirrup straps that work with the English slip-on fenders.
If you prefer a webber style strap, check out the T-bar and Conway Straps.

$65.00

Pocket shim for closed panels

Wedged shim inserted between base and closed panels. Perfect for those who want the classy look of the closed panels (especially with a matching color/material) but need a little lift in front to balance the rider for horses who might be downhill where the saddle wants to side or who have less curvature than the Ghost base. These work great with velcro opening panels too, and sometimes are a bigger solution than the felt shims that can go inside the panel. This is also the best balancing solution for the western saddle. Sold in pairs.

$25.00

Panel shims

Beveled wool felt shaped to fit the front of the Ghost panel. Two pieces per side, use the bigger one alone for a 1/4" lift, both together for a 1/2" lift. You can also shim one side more than the other if your horse has a bigger shoulder (shim the smaller shoulder).
To install, turn your saddle upside down on a level surface. Remove one panel only and open the velcro tab. Push one or both shims to the very front of the panel, close the velcro and reattach to the bottom of the saddle, using the stitch line of the base for positioning while comparing to the panel still in place. Repeat for the other panel.

$15.00