Girth rigging

Wedged shim inserted between base and closed panels. Perfect for those who want the classy look of the closed panels (especially with a matching color/material) but need a little lift in front to balance the rider for horses who might be downhill where the saddle wants to side or who have less curvature than the Ghost base. These work great with velcro opening panels too, and sometimes are a bigger solution than the felt shims that can go inside the panel. This is also the best balancing solution for the western saddle. Sold in pairs.

This is simply the most scrumptious and amazingly functional girth you'll ever find! Ordering the Oolala girth requires two measurements - the overall length as you would normally measure from buckle to buckle and the length of the center pad. This will allow you to have a girth that isn't bulky in your horse's armpit area. And most importantly, it can move with your horse. The pads are removeable for cleaning. The beauty of this girth is that you can choose the length of the center section depending if your horse is wide or narrow chested. You would choose the overall length the same as normal. But you can tweak as makes sense for a horse more sensitive in the armpit area. I have limited stock so will probably have to order, but I do have a couple sympanova backed girths in a "middle range" size that you can order and then return and order your correct dimensions and backing material if you are unsure about measuring. Here's a link to the main Ghost site with some videos - http://ghostsaddle.com/olala.html?fbclid=IwAR3UYZhfCGQl8aYsw6rzrlmNaPmwYTKPMxfEaz3-bRZspqqRjcF2GGfY4bE

Can affect the rider's pelvis tilt, refines the twist, and slightly deepens the seat. It goes under the front of the seat, with the wide side toward the pommel and the pointy side toward the rider. It can be moved forward/back for a greater effect.
Riders who have a low pelvic floor may not like the bolster. For those who are looking at the product to tilt the pelvis, one of the other rider balancing aids will have a great effect without discomfort.
To install, release the velcro under the front center of the seat, then tug the seat back over the front dees. Place the bolster and press the seat back into position, making sure all is still symmetrical. Replace the front velcro tab and push the seat back over the front dees. This last part can be difficult, especially when the saddle is new - to make it easier, pull some twine or a shoelace through the dee to give you more leverage.

These stirrup straps are thin, yet very strong. Made from granite biothane, they'll hold up longer than leather but don't create a bump under your leg. Even better when you run the buckle at the bottom and use the handy keeper to put the excess strap neatly out of the way.
The standard configuration Ghost stirrup straps are 1" granite biothane and can work with any stirrup style. These are the only Ghost stirrup straps that work with the English slip-on fenders.
If you prefer a webber style strap, check out the T-bar and Conway Straps.